2. PRINTER SETUP
2.10 Position and Print
Tone Fine
Adjustment
ONLINE
B-SA4T
V1.0
PAUSE
B-SA4T
V1.0
R
<1>RESET
R
F
<3>ADJUST SET
This section describes how to fine adjust a print start position, cut/strip
position, reverse feed amount, print tone, and ribbon motor torque.
When a fine adjustment is required, such as print start position, print tone,
etc, follow the procedure below.
1. Turn on the printer and confirm that "ONLINE" appears on the LCD
Message Display.
2. Press the [PAUSE] key to pause the printer.
P
3. Hold down the [RESTART] key for three seconds until "<1>RESET"
is displayed.
4. Press the [FEED] or [RESTART] key until "<3>ADJUST SET"
appears on the LCD Message Display.
5. When "<3>ADJUST SET." appears, press the [PAUSE] key to enter
P
the Parameter Fine Adjustment Mode.
E2-50
ENGLISH VERSION EO1-33048
2.10 Position and Print Tone Fine Adjustment