Ip Address Setting (Tcp/Ip) - Toshiba B-SA4TP SERIES Owner's Manual

2. PRINTER SETUP
2.7.3 IP Address Setting
(TCP/IP)
Power OFF
While holding down the [FEED] and
[PAUSE] keys, turn on the printer.
<1>DIAG. Vx.x
[FEED]
[RESTART]
<2>PARAMETER SET
[FEED]
[RESTART]
<3>ADJUST SET
[FEED]
[RESTART]
<4>TEST PRINT
[FEED]
[RESTART]
<5>SENSOR ADJ.
[FEED]
[RESTART]
<6>RAM CLEAR
[FEED]
[RESTART]
<7>IP ADDRESS
[FEED]
[RESTART]
<8>BASIC
[FEED]
[RESTART]
<9>FOR FACTORY
[FEED]
[RESTART]
When the printer is connected to a PC through TCP/IP by using a LAN
cable, it is necessary to set an IP address in the System Mode for system
administrators.
The System Mode for system administrators consists of the following
menus.
<1>DIAG. Vx.x
<2>PARAMETER SET
<3>ADJUST SET
<4>TEST PRINT
<5>SENSOR ADJ.
<6>RAM CLEAR
<7>IP ADDRESS
<8>BASIC
<9>FOR FACTORY
E2-24
ENGLISH VERSION EO1-33048
2.7 Setting an Operating Environment
This menu is used to check and print the printer
system information and maintenance counter
status.
This menu is used to set the printer parameters.
This menu is used to make a fine adjustment of a
print start position, cut position, etc.
This menu is used to perform print tests.
This menu is used to check the sensor statuses
and adjust each sensor.
This menu is used to perform a RAM clear.
DO NOT USE this menu.
This menu is used to set an IP address.
This menu is used to enable the printer to use
Basic program.
This menu is intended for an in-process
inspection. Do not use this menu.