Table of Contents
Advertisement
Configuration
5.1
Procedure when engineering
The function description of the machine provides the basis when engineering the drive
application.
Prerequisite:
Access to the "SIZER"
(https://support.industry.siemens.com/cs/document/54992004/sizer-for-siemens-
drives?dti=0&lc=de-WW) engineering tool, or
DT CONFIGURATOR (http://siemens.de/dt-konfigurator)
Catalog NC62
mc/intraDocs/catalogs/nc622019/NC%2062%20-%202019%20-
%20Complete%20Catalog/motion-control-NC62-complete-English-2019.pdf)
Procedure
1. The type of drive and supply (infeed) are clarified
2. Definition of supplementary conditions and integration into the automation system
3. The load is defined, the max. load torque is calculated, the motor selected
4. The SINAMICS Motor Module is selected
5. Steps 3 and 4 are repeated for additional axes
6. The required DC link power is calculated and the SINAMICS Line Module is selected
7. The line-side options (main switch, fuses, line filters, etc.) are selected
8. Specification of the required control performance and selection of the Control Unit,
definition of component cabling
9. Additional system components are defined and selected
10. The current demand of the 24 V DC supply for the components is calculated and the
power supplies (SITOP devices, Control Supply Modules) specified
11. The components for the connection system are selected
12. The components of the drive lineup are configured
❒
SIMOTICS M-1FE1 synchronous built-in motors
Configuration Manual, 09/2019, A5E47872980B AA
(https://intranet.for.siemens.com/org/i-dt-
5
77
Advertisement
Table of Contents
