Delete The Programming - TCS AMI1090 Series Product Information

01/2013

Delete the programming

Before an already programmed bell button can be programmed anew, the programming
must be deleted.
1
Shortly press the
RUN/PROG push button
2
◄6s►
Press the button until a negative
and positive acknowledgement tone sounds
3
Shortly press the
RUN/PROG push button
1) If there sounds an Progsperr tone instead, the programming lock of the front-door station is activated. The
programming lock can only be deactivated with the Service Device TCSK-01 or the configuration software
TM
configo .
TCS TürControlSysteme AG, TCS Hotline Deutschland: hotline@tcsag.de
www.tcsag.de
Initiate
Switch on the programming mode of the system
LED blinks
Delete a button
1)
End
LED is on
9
Namenplate of the bell button module blinks.
Programming mode of the system is switched on
Release
oder
Nameplate of the bell button module ON (or OFF).
Programming mode of the system is switched off.
Subject to technical changes.
PI_AMI1090x-uk 1A