Video Commissioning; Microphone And Loudspeaker Volume Setup; Nameplate Labelling - TCS AVU14 0 Series Product Information

Front-door station series with colour-video for flush-mount

Hide thumbs

Table Of Contents

Table of Contents

First fully install the system, then connect power!

• V1 and V2 must never - not even temporarily - be connected to the P, a or b wires.

Such a connection would destroy the device.

• When connecting the video wires V1 (+) and V2 (-) the polarity must be observed.

If the image is distorted after commissioning, switch off the device and replace the

wires for the video signal.

Microphone and loudspeaker volume setup

For adjustments use the small screwdriver supplied!

The volumes have been set to an average value

at factory. A modification may not always be

necessary.

When adjusting please note:

The amplification of loudspeaker and microphone

cannot be set independently from each other.

Too great volume will cause a feedback effect

(whistling).

The templates are available on our website

germany.com

\ English \ Downloads \ System and

technology basics \ Product installation and use \ la-

belling of the nameplate

1. Enter the desired name into the template. Print the

name plate on the special film* and cut it to size.

Alternatively write on the plates supplied.

2. Insert the cut plates from above into the pockets in

the name plate glass. Use the insertion aid (plastic

plate, supplied) to assist with opening the pockets.

The inserted name plates now protrude 2 mm at the

top of the pocket and can therefore be easily removed

for replacement purposes.

We recommend to print the name plates on a durable special film.

The film can be ordered directly from TCS: Writable polyester film

for name plates DIN A4.

TCS TürControlSysteme AG • Geschwister-Scholl-Str. 7 • 39307 Genthin

Phone.: +49 39 33 / 87 99 10 • Fax: +49 39 33 / 87 99 11 • www.tcs-germany.com