Set Working Mode; Cancel Timing - Midea Aqua Tempo Super Series Technical & Service Manual

Aqua Tempo Super Series air cooled scroll chiller unit (50Hz)
Press "Setting" key twice to enter hour setting
interface of "Timer 1 On"
Through the "▲" or "▼" key, set the hour
number of "Timing 1 On" to be 07
Press " " key to enter minute setting interface of
"Timer 1 On", adjust the minute number to be 10
Press " " key to enter hour setting interface of
"Timer 1 Off", adjust the hour number of " Timer 1
Off" to be 12
Press " " key to enter minute setting interface of
"Timer 1 Off", adjust the minute number to be 30
Whether press "OK" key
Yes
Successfully set the On time of
"Timer 1" to be 07:10 and O ff time
of "Timer 1 Off " to be 12:30, then
back to the main page.
The setting steps of "Timer 2" and "Timer 3" are the same as "Timer 1",
after setting all the settings then press "OK" key, and the3 timing periods
will be effective, and then back to the main page.
During any period of timing setting to press "OK" key , then the timing period has been set will be effective
(only when the "On" and "Off" of one timing period have been set then this period setting can be finished).
Press "Cancel" then cancel the setting. Query timing information: if query the timing hour which has been set,
press " " or " " key under main page, the On and Off time of Timer1, Timer 2 and Timer3 will be displayed
in turns.
Cancel timing: long press "Cancel" key for 3 seconds, then all the effective timing periods will be cancelled.
Note:
To avoid the timing error, each period of timing should not be crossed. E.g.:
TIMER 1
Correct:
5：00
8：00
TIMER 1
Wrong:
8：00
5：00 7：00
3) Set working mode (valid when wired controller set to 2,3,4)
Press "SET" key 3 times to enter the working mode setting when the main unit is off power. press the "▲"
or "▼" key to adjust , press "OK" key or wait for 7 seconds to be effective, and back to the main page;
During setting process to press "Cancel" key then will exit without saving. The controller will show
different working mode when it is applied to different main unit and set to 2,3,4 respectively.
Main page
No
Whether press "
Finish setting the On time of
"Timer 1" to be 07:10 and Off
time to be 12:30, then enter the
setting of "Timer 2".
TIMER 2
TIMER 3
10：00 12：00
18：00
TIMER 2
12：00
"Timer 1" setting
failed, after 7
seconds, the
page shift to
No
" key
Yes
22：00
125
MCAC-ATSM-201606