Setting Operating Modes And Parameters; Setting Water Temperature; Timing Setting - Midea Aqua Tempo Super Series Technical & Service Manual

Aqua Tempo Super Series air cooled scroll chiller unit (50Hz)
Turn on the unit
Power up to module unit and initially deliver
power to wire control.
Press "mode settings" key to set the
intended mode.
Press "OK" key to save the settings.
Unit will run after press "ON/OFF"
key 3 minutes later.

Setting operating modes and parameters

Press "Setting" key to enter the operation mode and parameters setting. The setting contents will change
as the following order each time the key is pressed:
1) Setting water temperature: under main page directly press the "▲" or "▼" to adjust the water
temperature, or press "Setting" key to enter and then press "▲" or "▼" to adjust. At that time the
main page twice to enter timing setting. At that time the LCD will display as the following:
TIMER
1
ON
Press the key again until all
modes are showed (i.e. Cooling,
Heating and Pump modes.)
→ →
→
MODE
LCD will display "Setting temperature" and "Water temperature
parameter" , as the following display. Query water temperature setting:
press the " " or " " key under the main page to query the set
water temperature numerical value.
2) Timing setting: can set 3 timing periods on the wire controller:
Timer 1, Timer 2, Timer 3, and then control the main unit to ON and
OFF in different periods. Setting method: press "Setting" key under
123
Tu r n o f f t h e u n i t
W h e n i n t e n d t o s h u t t h e u n i t
P r e s s " O N / O F F " k e y
To s e l e c t t u r n - o
TEMP. DIFFERENCE
MCAC-ATSM-201606
ff s e t t i n g s