Replacing Your Hard Drives - Nortel CallPilot Series Upgrade Manual

What is next?
If your server is a 201i or 1002rp, proceed to
(page

Replacing your hard drives

The following hard drives may not meet CallPilot 5.0 capacity requirements:
•
•
Replacing the 201i hard drive
Step
1
2
3
4
5
6
Replacing the 1002rp hard drives
Step
1
2
Copyright © 2007–2009, Nortel Networks
.
47). Otherwise, proceed to
Note: The upgrade wizard will detect if your hard drives need to be
upgraded.
The 201i hard drive must be a minimum of 20 GB
The 1002rp hard drives must be a minimum of 36 GB.
Action
Shut down the Windows operating system.
Remove the 201i server from the card cage.
Remove the hard drive. Refer to CallPilot 201i Server Maintenance
and Diagnostics (NN44200-500) for instructions.
Install the new drive.
Refer to the written procedure included in the CallPilot 5.0 IPE 201i
disk drive upgrade kit NTZE58AA for instructions.
Insert the server back into the card cage.
Proceed with Chapter 4 "Updating the server" (page
Action
Label the hard drives according to their position in the server. For
example, drives 1 to 6 from left to right. Keep these drives as a
backup in case you need to back out of the upgrade.
Power off the server and remove all hard drives.
Nortel CallPilot
Upgrade and Platform Migration Guide
NN44200-400 01.12 Standard
5.0 24 April 2009
Replacing your hard drives 47
"Replacing your hard drives"
"Splitting the RAID drives" (page
—End—
56).
61).