HELIX CTI-CRYOGENICS On-Board FastRegen Programming And Operation Instructions page 83

On-Board Module Replacement
Remote Keypad
Connector
Auxiliary TC Gauge
Connector
Network Pump
ID Switch
Network Terminal
Connectors
Figure 4-1: On-Board FastRegen Control Module Component Location
4-2
NOTE: The safety interlock screw must be in the vertical position before
the Power In cable can be connected. If necessary, turn the screw out 1/4
turn to set the screw in a vertical position as shown in Figure 4-1.
5. Connect the cables removed during Step 2.
6. Set the On-Board power switch to the ON position.
7. Refer to Section 3 - Programming and Operation to program the
new On-Board module.
Safety Interlock
Screw
Power In
Setpoint Relay
Connector
RS-232 Computer
Interface Connector
Power Indicator
-
C TI CRYOGENICS
HELIX TECHNOLOGY CORPORATION
P/N 8040406