Programming and Operation
RELAYS Function
3-54
The RELAYS function within the On-Board FastRegen Control Module
allows you to program the setpoint relays to open or close when a vacuum
system function occurs.
NOTE: Relay activation/deactivation is dependent upon the manner in
which the relays are wired, normally open or normally closed.
The RELAYS function parameters are shown in Figure 3-47. Relay
parameters and their ranges are provided in Table 3-4 and are described on
the following pages.
-
C
TI
CRYOGENICS
HELIX TECHNOLOGY CORPORATION
P/N 8040406