Komatsu PC1250-11 Original Instructions Manual page 152

EXPLANATION OF COMPONENTS
• When you press the switch F6 after inputting the ID
which is not registered to "Operator ID Change"
screen, a message is displayed below and the screen
changes to "Monitor Setting" menu screen.
In this case, the identified ID is not changed.
• On "Operator ID Change" screen, if no switch is oper-
ated for more than 30 seconds, the screen automati-
cally changes to "Monitor Setting" menu screen.
In this case, the identified ID is not changed.
KEY-ON CAMERA POSITION
On "Key-on Camera Position" menu, you can select the cam-
era image which will be displayed on the right side on the
screen when starting up the machine monitor.
• You can select one of three camera images from rear cam-
era, rear right camera, front right camera, and rear left
camera.
• Previous camera image which was displayed at the last
key-off is displayed when "Camera at Previous Key-off" is
selected.
1.
Select "Key-on Camera Position"(1) on "Monitor Setting"
menu screen, then press the switch F6.
2.
Select one camera position to be displayed on the right
side on the machine monitor, and press the switch F6,
then the camera position o be displayed at key-on is set.
The following operations are available with switches F3,
F4, F5, and F6 on "Key-on Camera Position" screen.
F3: Moves to the item below.
F4: Moves to the item above.
F5: Cancels the change and returns the screen to "Monitor
Setting" menu screen.
F6: Accepts change and returns the screen to the "Monitor
Setting" screen.
3-86
OPERATION