Preparing The Stand Alone Frame - Barco Prometheus III Installation Manual

5.4 Preparing the stand alone frame

Required tools
• Allen key 3 mm
• Nut driver
Required parts
• Stand alone frame
• 4 feet (floor mounting option)
Floor mounting
To install the standalone cooler in floor mounting mode follow this procedure:
1. Mount the 4 feet in such a way that the frame can stand stable. E.g. 2 on each short side or 2 on each long
side.
Image 5-19
2. Push the threat axle through one of the holes and secure with a washer and a nut.
Continue with "Installing the brackets on the cooler housing", page 54.
Wall mounting
To install the standalone cooler in wall mounting mode follow this procedure:
1. Place the stand alone frame against the wall (side indicated with 1) and mark the drilling hole. Any hole in the
frame can be used as fixation point but make sure to divide the fixation point over the complete frame.
It can be mounted in portrait mode (A) or in landscape mode (B).
Note: In portrait mode the coolers must be mounted with the cooling tubes up. In landscape mode the cooler
must be mounted with the cooling tubes to the left.
Physical installation stand alone cooler
R5906897 /02 Prometheus III 53