Table of Contents
Advertisement
Starting up
10.1 Switching ON the Prometheus III
This procedure is only done when projector was HARD switched-off.
How to switch on
1.
Make sure that the Prometheus III is installed upon a stable pedestal. See chapter "Positioning the
Prometheus III at port window", page 34.
2.
Ensure the external cooler is correctly installed. Check the connections: Tubes and electrical connections
must be secure and running from correct cooler to correct side. Ensure the tubes and electrical cables are well
protected.
3.
Make sure that the lens cap is removed and the correct lens is installed for your application. See chapter
"Lens selection", page 64.
4.
Make sure the projector is correctly connected to the power net. See chapter "Connecting the Prometheus III
with the power net", page 37.
5.
Check if a video source is connected with the projector. See chapter "Input & communication", page 81.
6.
Check if the communicator touch panel is installed. See chapter "Communicator Touch Panel", page 127.
7.
Press the power switch to switch ON the projector. As a result the projector starts up in standby.
Power switch status:
•
When '0' is visible, the projector is switched OFF.
•
When '1' is visible, the projector is switched ON.
8.
During this step some checking procedures are executed on the laser unit. The laser is OFF and the dowser
closed. No internal pattern is selected.
9.
After few moments, the communicator touch panel starts its initialization procedure, then the projector status
led turns Green (fix). The projector is in standby mode.
10.
Press the STANDBY button on the local keypad or use the Communicator Touch Panel to activate the laser.
11.
Press the DOWSER button on the local keypad or use the Communicator Touch Panel to open the dowser. As
a result the applied source will be displayed.
CAUTION: See user's guide of the Communicator Touch Panel to operate and control the
Prometheus III.
When for any reason a restart of the projector is required, the content server should be restarted
also.
10.2 Switching OFF the Prometheus III
How to switch OFF
1.
Press the standby button on the local keypad or use the Communicator Touch Panel to switch the projector
from operation to standby. As a result the lasers turn off but the fans remain turning and the cooling unit
remains working to cool down the projector.
2.
Let the projector cool down at least 5 minutes or until the speed of the fans decreases.
3.
Switch OFF the projector with the power switch.
134
R5906897 /02
Prometheus III
Advertisement
Table of Contents
