Table of Contents
Advertisement
Requirement
● The mounting cutout has been opened.
● Latch fasteners are readily available in the accessories. Clamps and setscrews are
Figure 5-6
Figure 5-7
Procedure
Proceed as follows to install:
1. Follow the installation instructions!
2. Insert the SIMOTION panel front (with the Panel PC Remote Kit, if necessary) into the
3. Secure the SIMOTION panel front to prevent it falling out of the mounting cutout.
4. Hook the brackets into the designated slots on the sides of the panel fronts, matching up
5. Secure the control unit in the mounting cutout from behind by tightening the setscrews
Note
The mounting depth increases by 21 mm when an optical drive is installed in the device.
Take the dimensions from the dimension drawings.
SIMOTION P320-3 and Panel Fronts
Manual, 02/2012
included in the scope of delivery.
Clamp assembly
Mounting brackets with setscrews - top view
prepared mounting cutout from the front.
the brackets with the dimensions of the mounting cutouts.
(torque 0.4 Nm to 0.5 Nm).
CAUTION
Risk of damage to the panel front
If you tighten the screws to a higher torque, this can damage the panel front (e.g. in the
form of fissures). Consequently, you should ensure strict compliance with the specified
values.
Installing/Mounting
5.5 Mounting the SIMOTION panel front
89
Advertisement
Table of Contents
