Fire Door Closing Function - Panasonic EBL128 Planning Instructions

Panasonic Eco Solutions Nordic AB
MEW01622 Rev: -
12

Fire Door Closing function

94
Programmable outputs
trigger condition is available (no. 44 = Fire Door Closing). Type of
output shall normally be "Control, neutral". One or more alarm points
can control the output, e.g. the detectors on both sides of the fire door.
S
01-01
Fire Door Closing function (ABDL)
In case of one of the following events, the output will be "activated"
(i.e. powerless) and the fire door will close:
 Fire alarm (from any of the programmed detectors)
 "Test mode" (the zone involved set in test mode)
 Fault (i.e. "no answer" from any of the programmed
95
detectors )
 Disablement (any of the programmed detectors or the
involved zone(s)).
 A definite time every day, if programmed via EBLWin.
(The output will be activated for 20 seconds.)
 Via a programmable input (trigger condition no. 9 = Door
Closing Test Input). (The output will be activated for 20
seconds.)
NOTE!
For safety reasons should an I/O unit 3361 output not be used.
there is short-circuit or a double break on the COM loop, the I/O unit
cannot be "ordered" to activate the output, i.e. the door will not be
closed.
If a magnet contact is available, it is possible to get a "closed fire door
verification" via the Interlocking function. In this case, Type of in-
/output has to be "Interlocking in-/output".
"Interlocking function", page 88.
94
It is recommended but in the DBI (Danish) convention, must only EBL128
outputs R0 and S0-S1 as well as the COM loop unit 3364 be used and "Type
of output" has to be "Control neutral".
95
E.g. a faulty detector, two breaks or short-circuit on the COM loop.
EBL128 Planning Instructions V2.0.x
can be used for fire door closing. A special
Fire
door
M Door release magnet
Programmable output
90
Smoke detector
S
01-02
94
If
See also chapter