Old Detector; Conventional Zone Line; Addressable Zone Interface; Output Unit - Panasonic EBL128 Planning Instructions

Panasonic Eco Solutions Nordic AB
MEW01622 Rev: -
2.2.8
2.2.9
2.2.10
2.3
2.4
2.5
2.6
2.7
2.8
2.9
(The unit can consequently be an I/O unit, to which one or more
conventional "alarm points" can be connected on the zone line.).

Old detector

Conventional detector with a closing contact (short circuit; no alarm
resistor), or detector with two breaking contacts.

Conventional zone line

Zone line input on e.g. an I/O unit, intended for one or more
conventional alarm points. End-of-line device in the last alarm point.

Addressable zone interface

Unit with a zone line input, intended for one or more conventional
alarm points. End-of-line device in the last alarm point.

Output unit

Addressable unit with programmable control outputs (e.g. an I/O unit).
To be connected to a COM loop (see below).

Output / Control output

Defined or programmable function. Relay or (supervised / monitored)
voltage output, in EBL128 or an output unit.

Short circuit isolator

Addressable unit for automatic isolation of a segment on a COM loop
(see below) in case of short circuit on the loop.

Display unit (D.U.)

Unit for fire alarm presentation (incl. alarm texts, if programmed).
Connected to an RS485 line.

COM loop

Loop = a cable (a twisted pair), to which all the addressable Panasonic
COM loop units can be connected. It starts in EBL128 and it returns
back to EBL128.

Control Unit (C.U.) / C.I.E.

Control Unit = C.U. = Control and Indicating Equipment (c.i.e.) = A
unit, e.g. EBL128, to which the alarm points are connected. Indicates
fire alarm, fault condition, etc. on the front, i.e. on the Fire Brigade &
Control Panel (see below).

Fire Brigade Panel (FBP)

The Fire Brigade Panel is a part of the EBL128 front, intended for fire
alarm presentation, etc. for the fire brigade personnel. A separate unit;
an external FBP, can also be connected to EBL128.
EBL128 Planning Instructions V2.0.x
11