Daylight Saving Time; Time Channels 1-14; Time Channels 15-63 - Panasonic EBL128 Planning Instructions

Panasonic Eco Solutions Nordic AB
MEW01622 Rev: -
13.23.1
13.24
13.25

Daylight saving time

The time is automatically changed when the Daylight saving time
period starts and stops respectively. This is depending on which
convention that is used.
 Australian convention: Forward 1 hour the first Sunday in
October, 02:00  03:00. Backward 1 hour the first Sunday in
April, 03:00  02:00.
 New Zealand convention: Forward 1 hour the last Sunday in
September, 02:00  03:00. Backward 1 hour the first Sunday
in April, 03:00  02:00.
 All other conventions: Forward 1 hour the last Sunday in
March, 02:00  03:00. Backward 1 hour the last Sunday in
October, 03:00  02:00.

Time channels 1-14

Time channel "Always off"
Time channel "Always on"
Time channels 2-14 are controlled by the built-in RTC (real time
clock). Up to five on/off times per day can be set for each time
channel.
The time channels can be used to:

disable and re-enable alarm points / zones

turn ON (enable) / OFF the Alert Annunciation function

activate programmable control outputs

turn ON (enable) / OFF the alternative alarm algorithm for analog
detectors
The properties for each Time channel (2-14) and each Day (Monday
to Sunday + National Holiday) have to be set, see chapter "Time
channels", page 142.

Time channels 15-63

Time channels 15-63 (ext. time ch. 1-49) are controlled by some
external device via a programmable input. Can be used to:

disable and re-enable alarm points / zones

turn ON (enable) / OFF the Alert Annunciation function

activate programmable control outputs

turn ON (enable) / OFF the alternative alarm algorithm for analog
detectors
One programmable input (trigger condition "External time channel")
per time channel (N). The input has to be connected to some external
device, e.g. a key switch, a timer, etc. with a normally open or a
115
EBL128 Planning Instructions V2.0.x