Interlocking Indications; Information Of Interlocking Combinations (H9); Display Interlocking Information (H9/C1); Activate Interlocking Output (H9/C2) - Panasonic EBL128 Planning Instructions

Panasonic Eco Solutions Nordic AB
MEW01622 Rev: -
11.2
11.3
11.3.1
11.3.2
Fault Detection Time: If the input is not activated within 5-255
seconds after the output is activated
FAULT: Interlocking input AA/PP
Date: MM-DD

Interlocking indications

One or more activated Interlocking Combinations (interlocking output
and/or input) are indicated in the display in EBL128
Interlocking input/output activated
See menu H9/C1
Disabled interlocking output is indicated by the LED "Disablements".
Information of interlocking combinations
(H9)
Menu H9 has the following sub menus.

Display interlocking information (H9/C1)

See also chapter "Interlocking indications", page 90.
In menu H9/C1 information will be shown as follows:
Output AA/PP activated at HH:MM
Interlocking text.. .. ..
or
Output AA/PP act HH:MM, input act HH:MM
Interlocking text.. .. ..
or
Input AA/PP activated at HH:MM
Interlocking text.. .. ..
AA = Interlocking combination Area
PP = Interlocking combination Point within the Area
HH = Hours
MM = Minutes
Use "↑" "↓" to scroll between several interlocking combinations.

Activate interlocking output (H9/C2)

Even if the control expression for an interlocking output is not
fulfilled (true), the output can be manually activated via this menu.
The "Interlocking Combination" (Area / Point) is to be entered to
activate the output. The corresponding interlocking input will be
"monitored" in the same way as if the output was activated by its
92
After the end of the delay time (if used).
93
This indication has low priority and will only be shown in the display if
there are no fire alarms, faults, disablements, etc.
EBL128 Planning Instructions V2.0.x
92
, a fault will be generated:
Time: HH:MM
88
93
: