Honeywell Tuxedo Touch User Manual page 40

How to Arm the System
Arming the system in any mode is performed in the same way, as described below.
Note: Close all perimeter windows and doors before arming and make sure the system says "Ready to Arm" on the
keypad. Or you can bypass zones you want left open to make the system "Ready to arm."
From the "Home" screen, press SECURITY
Stay , and Night
stating which zones are arming and whether or not there is an entry delay. The screen displays the exit delay countdown.
When exit delay time expires, the screen displays "Armed Away," "Armed Stay," "Armed Instant."
Notes:
1. If Quick Arm is not enabled in your system, a message to enter your User Code is received.
2. When the system is armed for Stay, Night Stay and Instant mode, Tuxedo beeps 3 times.
3. When the system is armed for Away and Maximum mode, you will hear steady beeps then rapid beeping during the last
10 seconds of Exit Delay.
4. For CP-01 installations, Maximum Mode cannot be used.
How to Arm Multiple Partitions
Note: Some systems may not have multiple partitions and the "Arm Multi-Partitions" option may not be available. In
addition, your code must be authorized to arm multiple partitions.
Press SECURITY > Arm Multi-Partition
authorized to access other partition(s) and highlight the partition from the list on the screen or select ALL to arm all
partitions listed. When done, press OK.
When exit delay time expires, the screen displays "Armed."
Notes:
1. A user may have access to some or all of the available partitions.
2. If the user code is accepted, the system displays the partitions that the user has access to.
3. If any zones are bypassed, "Display Faults" (
How to Display Faults (Zones)
If the system shows the "Not Ready Fault" message, it means a zone or zones are open (faulted). Zones must be
bypassed before you can arm the system. To display the open zone(s), do the following:
Press SECURITY > DISPLAY FAULTS
take corrective action such as closing a window or door to correct the fault.
If the fault cannot be corrected, you may choose to bypass a zone(s) by highlighting it and then pressing BYPASS
SELECTED .
To bypass all zones, press Bypass All
The Distressed Zones
, Faults , Bypass Zones
Using the Security System (cont'd)
. You can arm your system in one of three arming modes: Away
, could be an Instant mode as well. Press the selected Arming icon. A text message appears
) is displayed on this screen.
. A listing of faulted and/or bypassed zones is displayed. As applicable,
; to Refresh Data, press
is displayed when a zone is distressed. Distressed Zones include Alarm
, Low Battery
. Select the appropriate arming mode, enter the User Code
.
, and All .
36
,
, Troubles