Camera Configuration And Viewing; Viewing Cameras - Honeywell Tuxedo Touch User Manual

Using Pictures, Cameras and Videos (cont'd)

Camera Configuration and Viewing

Cameras can be viewed locally from the Tuxedo keypad.
To setup and view cameras for use with Wi-Fi enabled devices and Total Connect, refer to the Remote Access section
later in this document.
Camera functionality is supplementary only and has not been evaluated for
agency compliant applications.

Viewing Cameras

Your installer may have installed one or more cameras at the time of installation. If you want to add cameras to the
system, see the Adding Cameras to the System section.
Camera Icons
CAMER PLAY PAUSE
SETUP
IMPORTANT: Use the web browser to view cameras for non-security purposes only. Camera streams viewed from the
web browser can stop without indication due to network connection issues.
Note: Internet Explorer 11 - If the video streaming is not working, configure the browser for compatibility mode and
refreshed the web page.
Local Viewing
To view cameras locally, do the following:
Press Multi-Media > Camera View/Record
1. Highlight Camera; images from installed cameras appear.
2. Use Quad View to view up to four cameras on the same screen. Select a quadrant area on the screen and then
select the camera that you want to appear in that quadrant.
3. For pan/tilt style cameras, use Pan/Tilt to change the angle of the selected camera.
Remote Viewing
To view cameras remotely via a smart device or computer, do the following:
1. Press Multi-Media
2. Verify View Camera is highlighted. The cameras will appear in a Quad View mode, however, you can select
icon in bottom right corner for single view.
Select the quadrant area on the screen and then select the camera that you want to appear in that quadrant.
AUTO QUAD VIEW FULL VIEW PAN/TILT CONNECT RESET
PAN
. (Also available from the bottom right of the "Home Screen.")
.
11
RECORDING FULL VIEW
SETTINGS