Honeywell Tuxedo Touch User Manual page 11

Residential Mode
To enter Residential Mode (automation), from the "Home" screen press the following:
Setup > System Setup
"OPTIONS and OPERATING MODES" screen is displayed. Highlight the Automation Mode check box to enable
the option.
To change the occupancy delay time, (the amount of time you want to allow for authorized entry or exit without
causing an alarm) select a time interval from the Occupancy Delay drop-down list: choose from 15, 30, 60, 120 or
225 seconds.
When done, press Apply
The message is displayed: "Keypad will reset to activate changes." Select Yes
Commercial Mode
To enter Commercial Mode (automation), from the "Home" screen press the following:
Setup > System Setup
"OPTIONS and OPERATING MODES" screen is displayed. Highlight the Automation Mode check box to enable
the option then select the Commercial check box.
To change the occupancy delay time, select a time interval from the Occupancy Delay drop-down list: choose from
15, 30, 60, 120 or 225 seconds.
When done, press Apply
changes." Select Yes
Normal Mode
Normal Mode is used for security panel operation.
Demo Mode
Demo Mode allows the automation and multi-media features to operate in a non-security mode for demonstration
purposes only.
Safe Mode
In the rare event that Tuxedo cannot successfully communicate in its graphic mode with the control panel, the Safe Mode
is a backup mode that ensures that you can communicate with your system.
In this mode, the keypad operates much like a standard non-graphic keypad so that you can control your system until the
problem is corrected.
If this situation occurs, Tuxedo presents you with a message of "Problems detected. Start Keypad in Safe Mode?" and
requests a "Yes" or "No" response. If you answer with "Yes," Tuxedo enters into the Safe Mode. If you answer with
"No," Tuxedo tries to communicate with the panel again. After 3 consecutive times of receiving no response, Tuxedo
enters the Safe Mode automatically.
Note: Use care when providing the "Yes" or "No" response. Pressing the screen outside the prescribed area may cause
the background to come to the front. If this occurs, the Yes/No message that disappeared times-out in 30 seconds
even though it is not visible. Then Tuxedo resets into the Normal Mode (or Safe Mode if this is the third time that
the warning message appeared).
About the System (cont'd)
> CS Setup . Enter your authorized code and press Options
to save the settings.
> CS Setup . Enter your authorized code and press Options
to save the settings. The message is displayed: "Keypad will reset to activate
or No .
7
; the
or No .
; the