Creating Scenes - Honeywell Tuxedo Touch User Manual

Using Z-Wave Devices and Scenes (cont'd)

Creating Scenes

The system can automatically activate devices when certain triggered events occur. When a programmed
trigger/condition occurs, the defined device(s) activates. The programming of these triggers and actions is called Scenes.
A scene consists of a trigger, an optional condition, and up to five actions. Up to 30 local (20 more using Total Connect
Remote Services) scenes can be defined. Scenes must have at least one trigger and one action to initiate.
The user can access scenes by pressing Automation
set of icons. The table consists of 4 columns.
Column Description
SI.No Represents the scene number.
Name Names assigned to the scene.
Status Enabled or Disabled. This allows the option to enable or disable the scene for occasions the scene is
not desired
Manual Gives you the option to run the scene manually to verify its functionality. Also used for testing the scene
Run on initial setup to confirm all actions are taking place.
The other options are:
Name Description
Local Lists all of the scenes programmed locally in the keypad
Remote Lists all of the scenes programmed through Total Connect Remote Services. These scenes cannot be
edited, only viewed for their settings. The only option to edit is through Total Connect.
Press this icon to add a new scene.
Press this icon remove an existing scene.
Press this icon to edit an existing scene.
> Scene Setup . The screen will display a table and a
25