Honeywell Tuxedo Touch User Manual page 30

Using Z-Wave Devices and Scenes (cont'd)
Defining Scenes
The system can automatically activate various devices when certain events occur based on predefined Scenes.
Trigger
Defines the event that triggers the programmed action(s).
Triggers include the following categories:
Condition
Defines an optional event that puts a condition on the trigger. If a condition is set, the condition must
exist at the time of the trigger for the action to occur. Conditions include the same categories as
triggers. However, conditions cannot be set with the same category as the trigger. (ex., if setting a
trigger event for security, you cannot use security as a condition).
Action
Defines the desired device action when the trigger event occurs. Actions include the following
categories:
1. Press Add Scene .
2. Press Scene Name; enter a name.
3. Assign the desired "Condition," "Trigger," and "Action" for this Scene, See "Scene Options" section for detailed
information.
NOTES:
• After each selection press Save!
•
Scenes cannot be triggered using panic zones 995, 996 and 999 on commercial panels and panic zones 95, 96
and 99 on residential panels.
•
A scene consists of a trigger, an optional condition, and up to 5 actions.
Example: You want the lights to turn on when you arrive home and disarm the system, but only at night.
•
Trigger: "when the system disarms"  Set the Trigger to Security: System Disarm
•
Condition: "only at night"  Set the TIME condition (enter the Start Time and Duration)
•
Action: "Turn the lights ON"  Set the Action to LIGHT: ON.
Time Security
Garage Door Water Valve
Security Light
Garage Door Water Valve
26
Thermostat Door
Zones
Thermostat Door
Recording E-Mail