Sap Audio (Tvm550Iis) - Standard Communications TVM Series Owner's Manual

Option Installation

SAP AUDIO (TVM550IIS)

SAP Audio Parts Needed
1 SAP2000 Option Package
1 SAP PC Board
1 Ribbon Cable
1 Jumper
4 .. Screws
SAP Audio Installation Procedure
1. Remove the top cover of the unit containing the DSG2000 option package.
2. Locate the DSG2000 Stereo PC board (see Figure 5-16).
3. Position the SAP2000 PC board above the DSG2000 stereo PC board so
jack J6 on the SAP2000 PC board is as shown in the figure.
4. Connect the flat ribbon cable from jack P6 on the SAP2000 PC board to jack
P6 on the DSG2000 stereo board.
5. Install the SAP2000 PC board on the four existing standoffs, and secure it
with the four screws.
6. Install the supplied jumper over pins 3 and 4 on jack P9 on the DSG2000
stereo PC board as shown.
7. Replace the unit top cover.
Page 5-18 Owner's Manual TVM450/S/TVM550/S/TVM550II/TVM550IIS