CSG60 Inside Operations
1.
On the PK00 board located next to the heat sink inside the TVM450 or
TVM550. Follow the 3-wire cable (brown-gray-gray) to the power supply
board and disconnect it there.
2.
Unplug the coaxial cable connected to JM02 on the PK00 board.
3.
Remove the PK00 board.
Installing the PC Boards
1.
Install the P500 board in the spot where the PK00 board was removed ear-
lier. Orient the board so the side with crystal X501 faces the rear panel.
2.
Remove the screws from their posts on the right side of the unit (looking at the front panel) and
install the double-decked PK00 board as seen in Figure 5-8. Orient the board so the
black inductors along its short edge are closest to the heat sink. SCC's DBX
board is the upper board, and its line of blue potentiometers are on the left-hand side. The
four white connectors should be closest to the right edge of the unit.
TVM450/S/TVM550/S/TVM550II/TVM550IIS
Figure 5-8. CSG60 Cable Routing
Owner's Manual
Option Installation
®
9030
Page 5-7