Csg60; Csg60 Front And Rear Panels - Standard Communications TVM Series Owner's Manual

Option Installation

CSG60

See Figure 5-7 for panel controls and connections.
Figure 5-7. CSG60 Front and Rear Panels
CSG60 Installation
1. Verify that the CSG60 package contains:
•
One rear panel, complete with terminal strip, a terminal/connector mounting
strip, a long cable (connected to the VIDEO IN connector), and a short cable
for connecting the center pins of the VIDEO IN and the VIDEO OUT jacks;
•
One front panel plate, with interface board and attached cables;
•
One P500 PC board and attached cables;
•
One 75-ohm coaxial cable;
•
One 3-wire cable.
2. Remove the power cord from the modulator and disconnect all exterior cables.
3. To remove the modulator top cover:
a. Remove the front mounting brackets.
b. Remove the screws from the side panel, toward the rear of the unit.
c. Remove the cover screw from the rear panel.
d. Remove the top cover.
4. Remove the plate from the front panel of the unit labeled CMA60 monaural
audio module.
5. Remove the board behind the plate and the two cables (one 3-wire and one
4-wire) plugged into it, leading to the rear of the unit.
6. Remove the plate located on the rear panel and unplug the 5-wire cable and
the two coaxial cables from the PC board.
Save the rear plate and screws (these will be used later) and all PC boards
removed during this procedure.
Page 5-6
NOTE
Owner's Manual TVM450/S/TVM550/S/TVM550II/TVM550IIS
9036