Using The Optional Slide Rack Mount Kit - Avaya 8200 Installing Manual

About this task
Caution:
When you mount the device in a rack, do not stack units directly on top of one another. You
must secure each unit to the rack with the appropriate mounting brackets. Mounting brackets
cannot support multiple units. For a translation of this statement, see
messages on page 52.

Using the optional slide rack mount kit

The Universal Slide Rack Mount Kit is adjustable so that you can install your switch in equipment
racks of different sizes. Use the following procedures to install your switch in equipment racks with a
depth from 300mm to 900mm.
This kit is a separately ordered item (Part # EC8011002).
For instructions see:
• Installing slides in a 300mm-600mm equipment rack
• Installing slides in a 600mm-900mm equipment rack
• Important notice about rack safety
• Removing the switch from an equipment rack
Warning:
If you pull the switch all the way out on the slide rails, there is a danger of the rack tipping over.
For more information and guidelines, see
Installing slides in a 300mm-600mm equipment rack
Use the following procedure to install your switch in an equipment rack with a depth between
300mm and 600mm.
Procedure
1. Disconnect the power cord from the switch.
2. Use the following steps to detach the chassis rail from the slide's rack rail:
a. Pull the inner chassis rail and slide it out as far as you can.
December 2014
on page 31
on page 32
Important notice about rack safety
Comments? infodev@avaya.com
Installing the VSP 8200 in an equipment rack
Translations of safety
on page 19
on page 27
on page 31.
Installing the Avaya VSP 8200
19