Table of Contents
Advertisement
H
R
OW TO
ACK
M
MCU
OUNT THE
Located the front and rear side of each bracket.
Adjusted the length according to the rack depth.
Adjusted the length according to the rack depth.
To attach the brackets, you need all the parts from the Mounting Kit, including:
The right and left brackets, pre-adjusted to the rack's depth, as explained
in
Adjusting the Bracket Length
The eight Hexagon socket cap screw M6x10 (Din 7984).
The eight Cage nuts M6.
The Allen wrench 4 mm.
Procedure
Locate the holes in the rack post mounting strips, that you have selected
1
to attach the brackets and make sure that they are all at the same height.
Locate the two mounting holes at each side of each bracket, as shown in
2
Identifying The Bracket Parts
which bracket you are working on, as the left and right sides are
different for each bracket.
Using the Hexagon socket cap screw M6x10 (Din 7984) and the Allen
Note
Wrench, secure the front and rear sides of the left bracket to the
corresponding holes in the rack post's mounting strips.
Because the MCU chassis is heavy make sure to use both screws for
3
each connection and fully tighten them.
4
Repeat
Step 3
Safety Guidelines
Chassis Lifting Guidelines
Rack Mounting the SCOPIA Elite MCU
Attaching the System Ground
on page 11
on page 10. Make sure to first identify
on page 13 for the right bracket.
on page 14
on page 14
on page 16
Rack Mounting the SCOPIA Elite MCU
How to Rack Mount the MCU
on page 15
13
Advertisement
Table of Contents
