Table of Contents
Advertisement
DEFINITY Enterprise Communication Server Release 9
Installation and Maintenance for Survivable Remote EPN 555-233-121
1
SREPN Installation
Administer the Release 9r and SRP
6. The Member Assignments screen on the Release 9r system appears. Note
the number of the members in the trunk group.
Are all the ports for that trunk circuit pack members of that trunk?
7. Type save translation and press
Identify and add station information
1. On the Release 9r system, type list configuration port-network
<number> (number of the SREPN port network) and press
the slot numbers of the line circuit packs.
2. For each line circuit pack on the Release 9r system, type display port
<CCSS01> (where CCSS01 is the circuit pack and port location of the first
port on the line circuit pack) and press
appears. The Identification: field shows the type of station and its
extension for that port.
3. Type display station <extension> (extension of the station) and press
Enter
4. On the SRP system, type add station <extension> (extension is the same
station extension as above) and press
5. Duplicate all of the station information displayed on the Release 9r system
to the SRP system.
If yes, add the members, press
next trunk circuit pack.
If no, repeat step 2 for all the ports on the trunk circuit pack that are
not accounted for in that trunk group. (For example, if trunk group 98
has only 4 members, which correspond to ports 1 - 4, return to step
2 and type display port <CCSS05> and press
trunk group for port 5.) Then follow steps 3 and 4 with the new trunk
group information.
NOTE:
For more information about administering trunks, refer to DEFINITY
Enterprise Communications Server Release 9 Administrator's Guide.
.
NOTE:
The display command depends on the administration of that port -
display station for stations, display data for data terminals, and so
forth.
NOTE:
Remember to add any additional system administration that may be
needed. For example, if the station has a coverage path, you need to
administer the coverage path. Some of the administration for the
station may not work if the SREPN goes into survive mode (such as
coverage paths, abbreviated dial lists, and bridged appearances).
and repeat steps 2-6 for the
Enter
Enter
.
Enter
. The Port Information screen
Enter
.
Enter
Issue 2
November 2000
1-20
to determine the
. Identify
Enter
Advertisement
Table of Contents
