Table of Contents
Advertisement
DEFINITY Enterprise Communication Server Release 9
Installation and Maintenance for Survivable Remote EPN 555-233-121
2
SREPN Maintenance
Restore from remote location
Reseat the circuit pack
1. Reseat the circuit pack into the backplane connector.
!
2. Lift the locking lever until the pin engages.
3. Power up the cabinet.
Restore from remote location
The restore survivable-remote-link command reconfigures the EI link
connections to the Release 9r PPN just as if the faceplate switch was manually
set to the RSTR (Restore) position.
NOTE:
The TN2301 faceplate switch position overrides the restore survivable-
remote-link command, should the two conflict.
Once the connection to the Release 9r is repaired:
1. Dial in and log onto the SRP processor.
2. Type the restore survivable-remote-link command, which closes the
relay on the Processor circuit pack.
3. Wait at least 3 minutes while the EPN goes through its cold restart and
then check the status of the link connections with the status health
command for both the Release 9r and the SRP systems to determine
whether the link between the Release 9r and the EPN is up
page
When the connections are up on both sides (EPN and Release 9r), the
system is successfully reconnected.
WARNING:
Ensure that the fiber cables are not bent or pinched between the back
of the circuit pack and the backplane of the cabinet.
2-17).
Issue 2
November 2000
2-41
(Figure 2-9 on
Advertisement
Table of Contents
