SNMP traps
On each SPBM peer, if the SPBM B-VLANs are configured using different VLAN IDs (for example,
VLAN 10 and 20 on one switch and VLAN 30 and 40 on the second), no trap message is generated
alerting of the mismatch because the two switches cannot receive control packets from one another.
Be sure to configure the SPBM B-VLANs using matching VLAN IDs.
Others
• C-VLAN and B-VLAN cannot be enabled on the same port.
• Filters are not supported on the B-VLAN NNI port.
• Filters are not supported on the C-VLAN port for egress traffic.
Related links
SPBM design guidelines
June 2016
on page 138
Planning and Engineering — Network Design
Comments on this document? infodev@avaya.com
Restrictions and limitations
171