Konica Minolta SRX-101A Service Manual page 28

Error Display
DEV The "RUN" lamp will begin
Tempera flashing, the READY lamp
tures will remain lit, and the alarm
will sound.(PiPiPi, ...)
Flashing ON
RUN
READY
RUN
Film The "RUN" lamp will remain
Sensor lit, the READY lamp will
begin flashing, and the alarm
will sound.(Pi, Pi, Pi, ...)
Cause Response
The temperature levels (1) Check to see if the developer
for the developer have is being circulated properly.
dangerously risen above (2) Is the room temperature
the preset values, or around the processor
have remained below exceeding 30:?
these values for a long (3) Check for breaks in the
period of time. connection the developer and
dry sensor to the temperature
control board.
Detector lever of the film (1) Check the operation of the
sensor is kept engaged. detector lever at the entrance.
(2) Check the wiring between the
detector lever and the CPU
board. (refer to p.78)
Reset or Set Direction
Set
(1) Although 45 minutes has passed after the [RUN] SW is on, the dev. temp.
does not reach set value.
(2) When the dev. temp. does not rise although 5 minutes has passed after the
[RUN] SW is on.
(3) When the dev. temp. is over +/-3: of the range of preset value for 3 minutes
after the Ready Lamp is on.
Reset
When the power source is off.
Set
(1) When the film entrance sensor is kept engaged for 170 seconds at the 90
sec. processing, it is judged that the detector lever is locked up.
(2) When the film entrance sensor is kept engaged for 210 seconds at the 120
sec. processing, it is judged that the detector lever is locked up.
(3) When the film entrance sensor is kept engaged for 330 seconds at the 180
sec. processing, it is judged that the detector lever is locked up.
Caution : If the sensor is not disengaged after 25 minutes, the buzzer
beeps again. Detection made by the sensor that is judged to be
locked up will not be counted for replenishment.
Reset
When the machine is reset.