25) Attach the magnetic catch to the center for the Upper Light Shield.
26) Attach the steel plate to the film insertion table cover so that it hits the magnetic catch when the
cover is folded up. (See the diagram below)
27) Open(fold up) the film insertion table cover and make sure that the magnetic catch is strong
enough to hold it open while operating the SRX-101A.
28) Put back the top cover and make sure that the light shield is functioning properly from the
darkroom side.
Wall
Light Shield Panel
SRX-101A
INSTALLATION PROCEDURE
Magnetic
Catch
Steel Plate
SERVICE MANUAL
142