Configuring 10 Gb/S 9024Xl Ethernet Ports - Avaya Virtual Services Platform 9000 Series Configuration Manual

Ethernet module configuration using ACLI

Configuring 10 Gb/s 9024XL Ethernet ports

Prerequisites
You must log on to the Interface Configuration mode in ACLI.
Important:
You cannot configure Auto-Negotiation for 10 Gbit/s ports.
Important:
Ensure that all ports that belong to the same MLT or LACP group use the same port
speed.
Configure 10 Gbit/s Ethernet ports so they operate optimally for your network conditions. These
ports use the small form-factor pluggable (SFP) and small form-factor pluggable plus (SFP+)
connectors. Refer to
configuring SFP connectors.
SFP connectors are also supported on the 9024XL. Refer to Configuring100/1000Mbit/s 9048
Ethernet Ports for configuring SFP connectors.
Enable flow control:
tx-flow-control [port {slot/port[-slot/port][,...]}] enable
Variable definitions
Use the data in the following table to use the tx-flow-control command.
Table 15: Variable definitions
[port {slot/port[-slot/port][,...]}]
[enable]
32 Configuration — Ethernet Modules
Configuring 100/1000 Mbit/s 9048GB Ethernet ports
Variable Value
Specifies the port or ports that you want to
configure.
Enables flow control. After you enable tx-
flow-control, the TX port transmits MAC
control PAUSE frames to indicate congestion
on the receive side of the port interface. The
link partner ceases transmission based on
on page 29 for
June 2011