Avaya Virtual Services Platform 9000 Series Configuration Manual page 31

Table 13: Variable definitions
[port {slot[-slot][,...]}]
Use the data in the following table to use the tx-flow-control command.
Table 14: Variable definitions
[port {slot/port[-slot/port][,...]}]
[enable]
Configuration — Ethernet Modules
Variable
Variable
Configuring 100/1000 Mbit/s 9048GB Ethernet ports
Value
Specifies the port or ports that you want to
configure.
The no form of this command is
shutdown [port {slot[-slot]
[,...]}] .
Value
Specifies the port or ports that you want to
configure.
Enables flow control. After you enable tx-
flow-control, the TX port transmits MAC
control PAUSE frames to indicate congestion
on the receive side of the port interface. The
link partner ceases transmission based on
the MAC control frame pause-timer value.
The default is disable.
You can enable flow control only on 1 Gbit/s
and 10 Gbit/s ports. You cannot enable flow
control for ports that run at less than 1 Gbit/
s.
The default form of this command is
default tx-flow-control [port
{slot/port[-slot/port]
[,...]}] [enable]
The no form of this command is
flow-control [port {slot/
port[-slot/port][,...]}]
[enable] .
no
.
no tx-
June 2011 31