Avaya Virtual Services Platform 9000 Series Configuration Manual page 30

Ethernet module configuration using ACLI
1. Enable Autonegotiation:
2. Enable flow control as required:
3. Optionally, create a name for the port or group of ports:
4. Optionally, disable the interface:
Variable definitions
Use the data in the following table to use the auto-negotiate command.
Table 11: Variable definitions
[port {slot/port[-slot/port][,...]}]
[enable]
Use the data in the following table to use the name command.
Table 12: Variable definitions
[port {slot/port[-slot/port][,...]}]
<WORD 0-42>
Use the data in the following table to use the shutdown command.
30 Configuration — Ethernet Modules
auto-negotiate [port {slot/port[-slot/port][,...]}] enable
tx-flow-control [port {slot/port[-slot/port][,...]}] enable
name [port {slot/port[-slot/port][,...]}] WORD<0–42>
shutdown [port {slot/port[-slot/port][,...]}]
Variable
Variable
Value
Specifies the port or ports that you want to
configure.
Enables Auto-Negotiation for the selected
ports.
The default form of this command is
default auto-negotiate [port
{slot/port[-slot/port]
[,...]}] [enable]
To disable Auto-Negotiation, use the no form
no auto-negotiate
of this command:
[port {slot/port[-slot/port]
[,...]}] [enable]
Value
Specifies the port or ports that you want to
configure.
Configures a name for the port or ports.
.
.
June 2011