Avaya Virtual Services Platform 9000 Series Configuration Manual page 27

Important:
If you disable CANA on a port using the auto-negotiation-advertisements none,
or no auto-negotiation-advertisements commands, the port closes down until a
valid CANA setting is applied to the port. Resetting the device is not required for the setting
to take effect.
Configure 10/100/1000 Mbit/s Ethernet ports with Autonegotiation so that they operate
optimally for your network conditions. To use Custom Autonegotiation Advertisement (CANA),
you must enable Autonegotiation.
Important:
Avaya recommends that all ports that belong to the same MLT or Link Aggregation Control
Protocol (LACP) group use the same port speed. In the case of MLTs, the software does not
enforce this.
1. Enable Autonegotiation:
2. Configure CANA:
Variable definitions
Use the data in following table to use the auto-negotiate command.
Table 7: Variable definitions
[port {slot/port[-slot/port][,...]}]
[enable]]
Configuration — Ethernet Modules
Configuring 10/100/1000 Mbit/s 9048GT Ethernet ports with Autonegotiation
auto-negotiate [port {slot/port[-slot/port][,...]}] enable
auto-negotiation-advertisements [port {slot/port[-slot/port]
[,...]}] <10-full|10-half|100-full|100-half|1000-full|1000-
half|none>
Variable Value
Specifies the port or ports that you want to
configure.
Enables Autonegotiation for the port or other
ports of the module.
The default form of this command is
default auto-negotiate [port
{slot/port[-slot/port]
[,...]}] [enable]
The no form of this command is
negotiate [port {slot/port[-
slot/port][,...]}] [enable]
.
no auto-
.
June 2011 27