2-Wire/3-Wire Operation; Ring Tone Selection - TCS ISH3030 Product Information

07/2013

2-wire/3-wire operation

The jumper J1 is adjusted for 2-wire operation
in delivery condition.
2-wire operation (scope of delivery)
 Put the jumper J1 on the two upper con-
tacts for the 3-wire operation.
3-wire operation

Ring tone selection

For 4 different incoming calls (door calls of 2 different front-door stations, floor call, internal
call) different ring tones can be selected.
1 End communication. Press call OFF button for ca. 8 s.
Both LEDs are on and an acknowledgement tone sounds, the ring tone selection is
activated.
By pressing the following buttons a ring tone can be selected. You can chose be-
tween 13 tones.
select door ring tone
2a
from the front-door
station*
2b
select door ring tone
of floor door
2c select internal ring to-
ne
3
Press call OFF button short.
In case that no button is pressed for ca. 8 s, the device ends the ring tone selection
automatically. Both LEDs go out and an acknowledgement tone sounds, the ring
tone selection is deactivated.
* The ring tone is identical for all front-door stations and can be selected only identically for all.
For selecting a second door ring tone it is necessary to activate the call distinction by changing the audio AS limit.
Changing the audio AS limit is only possible with the configuration software configo™.
TCS TürControlSysteme AG
Mail: hotline@tcsag.de
11
J1
Press the door release button as often as the required ring
tone sounds. The ring tone selected last, will be stored.
Press the light switch button as often as the required ring
tone sounds. The ring tone selected last, will be stored.
Press the control key as often as the required ring tone
sounds. The ring tone selected last, will be stored.
Subject to technical changes.
ISH3030-0140 UK 2A