Table of Contents
Advertisement
07/2012
Connect the package components according to the wiring example home:packs.
Use the included small screwdriver to connect the lines and to avoid damaging the
!
device.
Front-door station (PAK or PUK) in 2-wire special operation
In this operation mode only one front-door station can
be connected!
A P-wire is to be realised by a bridge between terminal
a and P.
Note: The front-door station does not work, if the bridge
is connected to b instead of a.
Connect a door realease relay to the PAK or PUK
There is the possibility to connect a door release relay
if more than one front-door station is connected.
Please observe the product information of the
door release relay.
Connect the bell buttons to the built-in door loudspeaker ASI11000
The bell buttons provided by customer have to be
connected to the connection terminals (matrix points)
of the built-in door loudspeaker ASI11000 according to
the opposite illustration.
When installing additional (e.g. connected parallel ) comfort indoor stations, the max.
permitted number must be observed.
!
See product information indoor station.
Observe the information Installation and Technical data in the product information
ASI11000.
TCS TürControlSysteme AG
E-Mail: hotline@tcsag.de • www.tcsag.de
Connect the lines
indoor station with number as on
number sticker (1 and 2)
5
Subject to technical changes.
PI_home-packs-uk.doc
1A
Advertisement
Table of Contents
