Connection diagram 2-wire technique
Replacing an ISH1030 or TTS1 by an ISH3030
The floor push-button have to be connected always to the a-wire.
In case of a parallel circuit both telephones have to be replaced by the ISH3030.
Install the devices of the system voltage-free and completely.
Proof the a-, b- and P-wire against each other on short-circuit.
Switch on the main voltage.
Note:
If the floor push-button is not working, proof, i fit is connected to the a-wire of the power
supply and control unit.
Pre-adjusted times
communication time
flashing period of the green LED, if the voice
channal is busy after lifting the handset
internal standby time, if the device is calling or
is called
TCS TürControlSysteme AG
Mail: hotline@tcsag.de
10
Connection diagram 3-wire technique
Commissioning
Settings
max. 2 min
2 sec
around
30 sec
3 x flashing
Subject to technical changes.
ISH3030-0140 UK
2A
07/2013