Plastic Ties Removal; Assembly Completion - 3M -Matic a80b Instructions And Parts List

Adjustable case sealer with accuglide 2+ taping heads

Table of Contents

7-INSTALLATION (continued)

7.5 Removal of Plastic Ties

Cut any existing plastic ties (where applicable -

Figure 7-4).

1. Cut the plastic ties holding the lower

taping head in position. Hold taping head buff-

ing roller while cutting the plastic tie. Allow buff-

ing/applying arms to extend slowly (Figure 7-5).

2. Verify that the taping heads moves freely by

pushing the bufﬁ ng roller into the taping head.

3. Ensure that the tape drum bracket assembly

(located on the taping head) is mounted

vertically (as shown in Figure 7-6).

Note: The tape drum bracket assembly may be

pivoted to provide tape roll clearance if

necessary.

a80b-NA

Figure 7-5

7.7 Completion of Taping Heads

See Manual 2 for Complete Instructions:

Important – Do not cut against the apply roller -

roller damage could occur.

WARNING

•

To reduce the risk associated with

sharp blade hazards:



Keep hands and ﬁ ngers away from tape

cutoff blades under orange blade guards.

The blades are extremely sharp.

Figure 7-6

2011 April

Table of Contents