Lift The Machine To Where It Will Be Installed, And Position It; Preconditions For Correct Alignment And Secure Attachment; Checking The Load Handling Attachments; Removing The Rotor Shipping Brace - Siemens SIMOTICS FD 1LL1 Operating Instructions Manual

Assembly

5.2 Lift the machine to where it will be installed, and position it

5.2 Lift the machine to where it will be installed, and position it
5.2.1

Preconditions for correct alignment and secure attachment

Detailed specialist knowledge of the following measures is required in order to correctly align
and securely fit the equipment.
● Preparing the foundation
● Selecting and mounting the coupling
● Measuring the concentricity and axial eccentricity tolerances
● Positioning the machine
If you are not familiar with the prescribed measures and procedures, then you can make use
of the services offered by the local Service Center (Page 155).
5.2.2

Checking the load handling attachments

Inspect the load handling attachments such as the load trestles, lifting eyes and ring bolts and
also the lifting gear, before lifting the machine:
● Inspect the load handling attachments on the machine for possible damage. Replace any
● Before use, check that the load suspension equipment is correctly attached.
● When lifting the machine, use only approved and undamaged lifting gear of sufficient rated
5.2.3

Removing the rotor shipping brace

If a rotor shipping brace is attached to the machine, remove it at the last possible moment,
for example, when you are ready to push on the output or drive element.
50
load suspension equipment that is found to be damaged.
capacity. Check the lifting gear prior to its use.
WARNING
The machine can be dropped
If the load handling attachments and lifting gear are damaged or not correctly secured,
the machine may be dropped during lifting. This can result in death, serious injury or
material damage. Inspect the load handling attachments and lifting gear before use.
SIMOTICS FD 1LL1
Operating Instructions 04/2016