Switching Off The Anti-Condensation Heating; Regreasing Roller Bearings; Stoppages - Siemens SIMOTICS FD 1LL1 Operating Instructions Manual

8.3

Switching off the anti-condensation heating

NOTICE
Excessive machine temperature
If the anti-condensation heating is operated while the machine is running, this can increase
the temperatures inside the machine. This can result in material damage.
● Make sure that the anti-condensation heating is switched off before the machine is
● Only operate anti-condensation heating when the machine is switched off.
8.4

Regreasing roller bearings

Refer to the regreasing instructions for the roller bearings on the lubricant plate.
8.5

Stoppages

The stoppage is a shutdown for a period of time, during which the machine is stopped but
remains at the location of use.
Under normal ambient conditions, e. g. the stopped machine is not exposed to any vibration,
no increased level of corrosion, etc. in general, the following measures are necessary during
stoppages.
NOTICE
Damage due to improper storage
Damage may occur to the motor if it is not stored properly.
If the machine is to be taken out of operation for more than 12 months, suitable anti-corrosion,
preservation, packaging, and drying measures must be taken.
See also
Transport and storage (Page 34)
Start-up (Page 91)
SIMOTICS FD 1LL1
Operating Instructions 04/2016
switched on.
Operation
8.5 Stoppages
107