Relearn Procedure; Rear Quarter Window Removal - Jeep WRANGLER 2020 Owner's Manual

106 GETTING TO KNOW YOUR VEHICLE

Relearn Procedure

For vehicles equipped with a power top, there is
a relearn procedure that allows you to calibrate
the power top when the "Express Mode" stops
working. To reset the power top, follow these
steps:
1. Place the ignition in the RUN position, and
start the vehicle.
NOTE:
The engine must be running to perform the
relearn procedure.
2. Ensure the power top is in the fully closed
position.
3. Push and hold the Close switch for
10 seconds. This will put the power top into
calibration mode.
4. Continue holding down the close button
while the top goes fully open and then back
to fully close.
5. Once the power top has stopped in the fully
closed position, release the close button.
The power top is now reset and ready to use.
NOTE:
If the close button is released anytime during
the relearning process, the relearn may not be
complete, and the procedure must be repeated.

Rear Quarter Window Removal

On vehicles equipped with a Power Sliding Top,
the rear quarter windows can be removed.
To remove these windows, follow the procedure
below:
1. Open the swing gate, and lift the rear
window.
2. Open both side doors nearest the quarter
windows.
3. Locate the rear quarter window latches (two
on each window) on the interior of the
windows.
4. Rotate the left hand side latch clockwise to
release.
5. Rotate the right hand side latch counter-
clockwise to release.
Rear Quarter Window Release Latches
1 — Rotate Left Handle Clockwise
2 — Rotate Right Handle Counterclockwise