Wind Buffeting; Pinch Protect Feature; Power Top Maintenance; Ignition Off Operation - Jeep WRANGLER 2020 Owner's Manual

Manual Mode
To close the power top manually, push and hold
the close switch. The power top will move
forward and automatically stop at the fully
closed position. Any release of the switch will
stop the movement. The power top will remain
in a partially closed position until the switch is
pushed and held again.

Wind Buffeting

Wind buffeting can be described as the
perception of pressure on the ears or a
helicopter-type sound in the ears. Your vehicle
may exhibit wind buffeting with the windows
down, or the power top in certain open or
partially open positions. This is a normal
occurrence and can be minimized. If the
buffeting occurs with the rear windows open,
then open the front and rear windows together
to minimize the buffeting. If the buffeting occurs
with the power top open, adjust the power top
opening to minimize the buffeting or open any
window.

Pinch Protect Feature

This feature will detect an obstruction in the
opening of the power top during Express Close
operation. If an obstruction in the path of the
power top is detected, the power top will
automatically retract. Remove the obstruction if
this occurs. Next, push the close switch and
release to Express Close.
WARNING!
There is no anti-pinch protection when the
power top is almost closed. To avoid personal
injury be sure to clear your arms, hands,
fingers and all objects from the top's path
before closing.
NOTE:
The Power Sliding Top may reverse motion if

closing during a severe headwind. If this
occurs, push and hold the Power Sliding Top
switch again to close the top completely.
If three consecutive power top close

attempts result in Pinch Protect reversals,
Pinch Protect will disable and the power top
must be closed in Manual Mode.
GETTING TO KNOW YOUR VEHICLE

Power Top Maintenance

Use only a non-abrasive cleaner and a soft cloth to
clean the quarter window glass panel.
Refer to "Bodywork" in Servicing And Maintenance"
for further information. It contains important
information on cleaning and caring for your vehicle.

Ignition Off Operation

The power top switch can remain active in
Accessory Delay for up to approximately
10 minutes after the vehicle's ignition is placed
to the Off position. Opening either front door will
cancel this feature.
NOTE:
Ignition Off time is programmable through the
Uconnect System. Refer to "Uconnect Settings/
Customer Programmable Features" in "Multi-
media" for further information.
105
2