High/Low Beam Switch; Automatic High Beam - If Equipped; Flash-To-Pass; Automatic Headlights - If Equipped - Jeep WRANGLER 2020 Owner's Manual

44 GETTING TO KNOW YOUR VEHICLE

High/Low Beam Switch

Push the multifunction lever toward the
instrument panel to switch the headlights to
high beams. The lever will return to the centered
position. To return the headlights to low beam,
pull the lever toward the steering wheel, or push
the lever toward the instrument panel.
Multifunction Lever
Automatic High Beam — If Equipped
The Automatic High Beam Headlamp Control
system provides increased forward lighting at
night by automating high beam control through
the use of a digital camera mounted on the
vehicle's header. This camera detects vehicle
specific light and automatically switches from
high beams to low beams until the approaching
vehicle is out of view.
NOTE:
The Automatic High Beam Headlamp Control

can be turned on or off by selecting "ON"
under "Auto High Beam" within your
Uconnect settings, as well as turning the
headlight switch to the AUTO position and
placing the multifunction lever in the high
beam position. Refer to "Uconnect Settings"
in "Multimedia" for further information.
Broken, muddy, or obstructed headlights and

taillights of vehicles in the field of view will
cause headlights to remain on longer (closer to
the vehicle). Also, dirt, film, and other obstruc-
tions on the windshield or camera lens will
cause the system to function improperly.

Flash-To-Pass

You can signal another vehicle with your
headlights by lightly pulling the multifunction
lever toward you. This will cause the high beam
headlights to turn on, and remain on, until the
lever is released.
Automatic Headlights — If Equipped
This system automatically turns the headlights
on or off according to ambient light levels. To turn
the system on, rotate the headlight switch
clockwise to the last detent for automatic
headlight operation. When the system is on,
the headlight time delay feature is also on.
This means the headlights will stay on for up to
90 seconds after you place the ignition into the
OFF position. To turn the automatic system off,
move the headlight switch out of the AUTO
position.
NOTE:
The engine must be running before the head-
lights will come on in the automatic mode.