Jeep WRANGLER 2020 Owner's Manual page 68

66 GETTING TO KNOW YOUR VEHICLE
Soft Top In Place
6. Using the provided #40 Torx head driver
and ratchet, tighten the Torx screws by
turning them clockwise. Secure them until
they are snug (refer to the table below for
recommended torque specifications), being
careful not to cross-thread the screws or
overtighten. Repeat on the opposite side.
Lift Assist Mechanism In Place
1 — Lock Position
2 — Torx Head Screw
3 — Torx Head Screw
Torque
Specification
Maximum
For Torx
Screws
119.5 in-lbs 150.5 in-lbs
13.5 N·m 17.0 N·m
CAUTION!
Do not overtighten the screws. You can strip
the screws if they are overtightened.
7. While pulling the release lever on the top of
the rail rearward, place the side link into the
guide track on the top of the rail then
release the lever.
8. Unsnap and remove the black boot cover. This
cover should be discarded. It was intended as a
Minimum
protective cover for shipping only.
NOTE:
106.2 in-lbs
A visual instruction sheet is included with the
12.0 N·m
vehicle.
9. Raise the soft top. Refer to "Raising The
Soft Top" in this section.
NOTE:
Be sure the wire harness in the left rear corner is not
tangled in the soft top bows before you lift the top.
Step Seven