17 SK-91460T-144PMC(-GPIO)
This chapter describes the needed settings for programming the MB91F467T on the
starterkit SK-91460T-144PMC.
The SK-91460T-144PMC is a multifunctional evaluation board for the Fujitsu 32bit flash
microcontroller MB91F467T in LQFP144 package. The board is used stand-alone for
software development and testing.
For serial asynchronous programming SUB-D9 connector X2/LIN-UART4 which is
connected to UART4 has to be used. Following jumper setting is needed:
Jumper
JP21
JP25
JP27
Table 36: Jumper setting on starterkit SK-91460P-144PMC
© Fujitsu Microelectronics Europe GmbH
Serial Asynchronous Flash Programming
Chapter 17 SK-91460T-144PMC(-GPIO)
Figure 63: Connection to starterkit SK-91460T-176PMC
Setting
Description
1 - 2
SIN4 is connected to RS232 transceiver
1 - 2
SOT4 is connected to RS232 transceiver
1 - 2
X2 pin 2 is connected to RS232 transceiver
- 67 -
MCU-AN-300012-E-V13