Fujitsu MB91460 Series Application Note page 57

Jumper
JP21
JP25
JP27
Table 26: Jumper setting on starterkit SK-91F467B-144PMC
If your programming software needs connection of RTS and CTS or if it generates reset
signal on RTS or DTR line, refer to the following jumper list:
Jumper
JP20
JP89
JP16
JP13
JP38
Table 27: Jumper settings for reset signal on starterkit SK-91F467B-144PMC
© Fujitsu Microelectronics Europe GmbH
Serial Asynchronous Flash Programming
Chapter 12 SK-91467B-144PMC
Setting Description
1-2 closed MCU SIN4 connected to RS-232 transceiver
1-2 closed MCU SOT4 connected to RS-232 transceiver
1-2 closed X4 pin2 is connected to RS-232 transceiver
Setting Description
closed RTS and CTS is shortcut at connector X4
open RTS and CTS is not shortcut at connector X4
1-2 closed DTR can be used for system reset
2-3 closed RTS can be used for system reset
closed Reset will be done via UART4
1-2 closed No polarity inversion for the DTR/RTS signal
2-3 closed Polarity inversion for the DTR/RTS signal
closed External reset generation is active
- 55 - MCU-AN-300012-E-V13