Serial Synchronous Programming With Galep-4 Programmer - Fujitsu MB91460 Series Application Note

4.1.2 Serial Synchronous Programming with GALEP-4 Programmer

Conitec offers an ISP-adapter (210865) for all devices with serial-synchronous burn-in
bootloader. This adapter will be put into the Textool
used for the connection to the microcontroller.
All MB91460 series starterkits provide a 10pin connector to connect the programmer tool.
Figure 19: 10pin connector for serial synchronous programming
Pin Number Pin Signal
1
2
3
4
5
6
7
8
9
10
Figure 20: Serial Synchronous Programming on SK-91F467D-208PFV
MCU-AN-300012-E-V13
Serial Asynchronous Flash Programming
Chapter 4 GALEP-Programmer
Description
NC Not used
NC Not used
MD0 MCU mode-pin 0
MD2 MCU mode-pin 2
INITX MCU reset signal
SIN4 UART4 receive data
SOT4 UART4 transmit data
SCK4 UART4 clock
VCC Board supply voltage
GND Ground
Table 7: Pining of 10pin connector
TM
socket and a 10-pin cable-connector is
- 24 - © Fujitsu Microelectronics Europe GmbH